New kit announcement, Junebug (PICKit2 SE & Firefly)

[@t]

Hoi Blueroom,

Nice design. Do you sell the board alone or also compleet with components?



It's three weeks later now, a pity that blueroom electronics doesn't answer anymore

@t.

 

[mvs sarma]

Hoi Blueroom,

Nice design. Do you sell the board alone or also compleet with components?



It's three weeks later now, a pity that blueroom electronics doesn't answer anymore

@t.

Perhaps you haven't seen their site. You will find, assembly instruction manual . Even the price can be had from there itself.
www.blueroomelectronics.com

 

[@t]

@t.[/quote]
Perhaps you haven't seen their site. You will find, assembly instruction manual
---
Thank you mvs sarma, I'll take a look. But an answer from him concerning his graphic drawings would have been nice, they look good.
Greetings, At.

 

[hngm]

Hepl me, IRLM6402 datasheet
thank

 

[blueroomelectronics]

I don't use the IRLM6402 in the Junebug.

Added after 54 seconds:

Hoi Blueroom,

Nice design. Do you sell the board alone or also compleet with components?



It's three weeks later now, a pity that blueroom electronics doesn't answer anymore

@t.

Didn't notice the message, email works and yes it's a kit with all components

 

[coolcat]

Hi blueroomelectronics

From the JuneBug schematic, I found that the Q2 BS250P and LED AMBER is different from the original PICKIT2. The original PICKIT2, FDC6420C (P) pin S is connect to 5V and pin D connect to diode while the orientation for BS250P in junebug is different. The LED from PICKIT2 is active high while LED in Junebug is active low.

May I know why you design like this? Will the VDD still work with this combination?