Heat Sink Design

[engr_joni_ee]

I have designed a heat sink.

The dimensions are shown in attachment. I am bit concerned with the 1.5 mm.
Is that possible to manufacture ?

 

[FvM]

These days, it's very likely that Wakefield has step files. If they are not freely offered on web site, you can  kindly ask them.

"Extruding" the 2D footprint from datasheet in a 3D tool should give an acceptable 3D model, b.t.w.

 

[engr_joni_ee]

These days, it's very likely that Wakefield has step files. If they are not freely offered on web site, you can  kindly ask them.

"Extruding" the 2D footprint from datasheet in a 3D tool should give an acceptable 3D model, b.t.w.

Thanks. I made it in Solid Edge.