Verilog-a code to latch analog voltages

Status
Not open for further replies.
C

Chinmaye

Full Member level 3
Joined
Jan 18, 2016
Messages
164
Helped
0
Reputation
0
Reaction score
1
Trophy points
1,298
Activity points
3,145
Dear all,
I am trying to model analog latch in verilog-a but have been unable to do it. The requirement is as follows
It is required to sample an analog value at positive clock cycle of CLK2 and hold the same value even during the negative clock cycle of CLK2.
Any leads??
 

@cross() does not allow V() inside it. Hence it cannot be used
 

Chinmaye said:
@cross() does not allow V() inside it.
Hence it cannot be used
Click to expand...
No.
You can not understand Verilog-A at all.

if V(clk2) >=0 aho = V(in);
@cross(V(clk2), -1) aho = V(in);
V(out) <+ aho;
 
Last edited:

Look at page 113 of **broken link removed**

Your exact solution is given!!
 

vivekroy said:
Look at page 113 of **broken link removed**
Your exact solution is given!!
Click to expand...
This is not transparent latch.

For V(Clk2)=High, V(out)=V(in) ; Tranparent
Then V(in) is captured at negative edge of V(Clk2).
V(out) is constant during V(Clk2)=Low ; Hold Mode.
 
Here you go

Code: 
// VerilogA code

`include "constants.vams"
`include "disciplines.vams"

module veriloga_latch(vin,vclk,vout_sampled);
input vin,vclk;
output vout_sampled;
voltage vin, vclk, vout_sampled;
parameter real vdd=1;
real vsample=0;
analog begin
	if (V(vclk)>0.9*vdd) begin
		vsample=V(vin);
	end
	V(vout_sampled) <+ vsample;
	end
	


endmodule

Here is the op:
 
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…