USB Pic programmer problem

Status
Not open for further replies.

In that picture choose art2003 programmer.
 

someone have pickit3clone schematic?
 

I migrate from jdm to pcikit2clone i\'m happy how this works.
 

Yes, JDM is old but still in use, its good for usage over RS-232. PICKit2 have much better device support and capabilities. I switch from PICKit to MikroProg.
 

While Pickit 2 is connected to computer then its (PIC18F2550) get heated slightly. Is it normal or a problem? i checked many times but would not find any fault in IC output.
 

I didnt notice any heating on my PICKit 2 Clone. Now I using MikroProg as PIC programmer.

Check all connections and parts. Somewhere you drain more current than planned.

Check PCB on shortcircuit.
 

it works well but slightly heated. Is it ok?
i checked many times but would not find any fault in IC output.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…