Unknown inductor and smps transformer

[Edblue95]

Hi good day everyone I have an inquiry about what type of inductor and smps transformer it is from the two pictures. I think the smps transformer is slot type not sure. The inductor is radial that's half inch thick or almost .5 inch and the smps transformer is beige with layers here are the pictures. For replacement because of dust.

 

[betwixt]

"replacement because of dust"? brush it clean of blow the dust away with compressed air, they are not damaged.

The inductor is a standard Ferrite cored one, you would need to measure its inductance to find a replacement but the chances of it being faulty are almost zero.
If you mean the 'transformer on the right in the second picture, it looks like a transformer but it is actually a filter choke to reduce radiated interference down the power cord (black and white wires). Again, failure is extremely unlikely, I don't think I have ever seen a faulty one. Look on the web sites of TDK and Murata, they are the main manufacturers of these devices.

Brian.

 

[FvM]

The transformer at the left image border is surely custom made, there's unlikely an off-the-shelf type fitting it.

 

[Edblue95]

I couldn't find the inductance of the inductor the one that's marked L5001 but I know it has more than 17 turns and the transformer on the left I think it's a slot type smps transformer but I need to be sure. The filter choke on the right I already found the replacement

 

[barry]

I’m with Brian. If we had to replace every electronic device because of dust…

 

[betwixt]

... I think I would have to replace my whole workshop if dust was the problem !

Brian.

 

[Edblue95]

I still need to identify the inductor and if the transformer I have is smps slot type the receiver still won't turn on after removing dust.

 

[betwixt]

Inductors are very rarely the cause of SMPS failure. Most problems are due to electrolytic capacitors dropping in value, particularly smaller ones in the input stages.
I think you are looking for a fault in the wrong place.

Brian.

 

[FvM]

I just learned that "slot type" transformer is another word for a transformer with multi-section coil former, doubt that it's a commonly understood technical term.

Anyhow, does the info help you to find a replacement for an unknown custom made transformer?