Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

STM32F302 as USB Virtual Com Port Device.

Status
Not open for further replies.
B

btbass

Advanced Member level 5
Advanced Member level 5
Joined
Jul 20, 2001
Messages
1,897
Helped
438
Reputation
882
Reaction score
289
Trophy points
1,363
Location
Oberon
Activity points
12,888
I am trying to use STM32Cube to generate a VCP Usb device framework for the STM32F302CB micro.

It works fine for a STM32F405 chip and a STM32F103 chip.

But on the 302, it just wont enumerate properly?

The only differences I can see are the 302 supports USB Device only, while the others have OTG support.

Has anybody got the STM32F302 working as a usb device using the HAL drivers and STM32Cube?
 

Still can't get this chip to enumerate using the STMCube and the HAL framework.
The Hardware is sound. If I hold the Boot_0 pin high, it fires up every time and enumerates as a bootloader.
But the VCP code just wont enumerate properly???

Is anybody working with the STM32F302 as a usb device?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top