Sine Wave Inverter using PIC16F84A Microcontroller

Status
Not open for further replies.



No there are two Mosfets at the transformer driver board.The third at the board with the pic16f84a is the 5 volts regulator to power the pic16f84a.
The output is around 230v without a load at transformer.And i dont know much about the proteus but i think 40mv is the division for signal measurement at the oscilloscope.
may be someone else could explain it better.
 

the proteus oscilloscope image



Mr hamed is using 12 voltages as input u can get high voltage like 220v if u change the transformer turn ratio, . . .
 

can anyone say how to view this schematic .DSN file ? I dont have Orcad installed
thanks !
 

@amadjo01 Hi !
yes i have Proteus but it refuses to open it even though the file icon is correctly shown
Proteus message says the file is made in a later version of Proteus so cant open it.
Thanks for your suggestion.
EDIT: i upgraded from ver 7.4 to 7.5 and now i can see the circuit but it is only a simulation.Without the hex code it is useless.
 
Last edited:


yah...
wheres the Hex code....
 

here's a modified sine wave inverter using PIC16F628A and the hex code is given at the bottom of the page for both 50Hz and 60Hz
**broken link removed**
 

tipu electronics said:
here's a modified sine wave inverter using PIC16F628A and the hex code is given at the bottom of the page for both 50Hz and 60Hz
**broken link removed**
Click to expand...

where protection ? just like ..low batt cut off , over load cut off & mains change over (for mains & Inverter)..
 

Hi, liteon thanks for your analysis about the Pakistanis.
I think you are one of them who don't share their knowledge, and you must be ashamed of what you wrote here.

---------- Post added at 07:43 ---------- Previous post was at 07:34 ----------
tipu electronics said:
can anyone say how to view this schematic .DSN file ? I dont have Orcad installed
thanks !
Click to expand...
Hi Tipu,
Try to download the latest version here.
Proteus
 
Last edited:


Sohaib if you have latest version of Proteus.You can change schematic into bitmap view.
It will be helpfull for members,those do not have proteus(or latest version which can open this DNS file).
Bitmap can be import from Proteus window as,
FILE/EXPORT GRAPHICS/EXPORT BITMAP/RESOLUTION/600DPI.
with best wishes
 

Attachments

  • 58_1317152074.jpg
    431.5 KB · Views: 311

Thanks for the attachmens but i've for how much Hertz (Hz) and power (W) is this shematic with pic 16f84 ?? what trafo i can use?! i have home 400W 2x14 ;2x10V primar to 220 sekundar?!
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…