STMONO
Newbie level 1
Hi all,
I would like to stop Sdevice for any reason while it is doing its job and resume it again afterwards.
By aborting the project it will start everything again while cleaning all the previous results for the next run of the node.
Is there any way to resume Sdevice from the point which I have stopped it?
There is a save load option in manual but frankly speaking I didn't understood usage of it.
A practical example would work much better.
Thanks
I would like to stop Sdevice for any reason while it is doing its job and resume it again afterwards.
By aborting the project it will start everything again while cleaning all the previous results for the next run of the node.
Is there any way to resume Sdevice from the point which I have stopped it?
There is a save load option in manual but frankly speaking I didn't understood usage of it.
A practical example would work much better.
Thanks