Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Power Signal Generation

Status
Not open for further replies.

sabu31

Advanced Member level 1
Advanced Member level 1
Joined
Jan 28, 2011
Messages
467
Helped
12
Reputation
24
Reaction score
13
Trophy points
1,298
Activity points
5,359
Dear All,

I want to generate a power signal of a particular waveform. I am attaching the figure of the required waveform. What should be the configuration of L-C circuit along with pulse circuit for this to be realized. Typical voltage level of 400-500V.

Burst.png
 

Is this for some ultrasound application? The voltage/power levels and the waveforms shape are not far off from ultrasound/sonar/sodar. I would look at literature regarding ultrasound drivers and transducers.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top