Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

opamp issues in multisim ewb

Status
Not open for further replies.
R

robismyname

Full Member level 6
Full Member level 6
Joined
Jan 17, 2008
Messages
390
Helped
11
Reputation
22
Reaction score
9
Trophy points
1,298
Location
Central Florida
Activity points
4,603
My Op Amp (non-inverting) does not work. I see the function generator signal on the oscilloscope channel 1 but I dont see a sine wave output of the opamp on channel 2.

Any help is appreciated.......
 

Your power supplies are backwards. +12V has to be on pin 8. -12V on pin 4. Correct the circuit and give it a try. I checked it. It works.
 

AdrianN said:
Your power supplies are backwards. +12V has to be on pin 8. -12V on pin 4. Correct the circuit and give it a try. I checked it. It works.
Click to expand...

Gain (AV)=1+10000/1000 = 10

My Vin measured with o-scope is 400mV although my function generated is set to 100mVp (sine wave), 1kHz.....

My Vout is 4.4 volts

How am I getting 400mV for Vin, when my function generator is set to 100mVp?
 

XFG1 is bipolar. You need to ground the middle output called "common". The setting is 100mVp, which means that, after connecting common to ground, you will have an amplitude of 200mVp-p (peak to peak).
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top