Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Microstrip Balun Design using ADS

Status
Not open for further replies.
I made a draft phase shifter, it's a narrow band, and its S21 is a little big, and S11&S22 is not so good, but anyway, the phase shift is OK, I guess.
Just for your ref.
 

Attachments

  • Phase_shifter1.JPG
    Phase_shifter1.JPG
    281.4 KB · Views: 96
  • Phase_shifter2.JPG
    Phase_shifter2.JPG
    64.5 KB · Views: 86
  • Phase_shifter3.JPG
    Phase_shifter3.JPG
    80.6 KB · Views: 83
  • Phase_shifter4.JPG
    Phase_shifter4.JPG
    48.5 KB · Views: 91

i am designing a 4 way wilkinson power divider but i am not getting the desired results.
I have to implement it wideband i.e 5GHz-15GHz.

After division into 4 parts, the S parameters have variations from the desired value and there is a difference between S21, S31, S41, S51.

Please help me out.

Each wilkinson network has N=3 and i have accomodated 3 such two way wilkinson dividers.
 

That bandwidth is too wide, you need to check the AWR examples about power divider, it is for 2-18GHz.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top