the.cycler
Newbie level 5
@mrflibble:
Thank you!
I didn't know about SAGE. I have not used it at all. I have already Scilab installed, I think is enough for every EE task you can put it to do...
Should I use Sage because of python scripting?
I had eaglecad installer (for the user to opt for it) included in previous version but i took it out. If it is needed I can put it back in a later version...
LTspice has a very good spice engine. It runs under wine (installed). Maybe it is a good idea...
Recently I tried a SCR simulation but i could not find a good model in LTspice. Qucs did well in the same task. I changed the parameters in the built-in model and gave accurate results. Besides that LTspice is very good.
I'll check about SDCC...
Thank you!
I didn't know about SAGE. I have not used it at all. I have already Scilab installed, I think is enough for every EE task you can put it to do...
Should I use Sage because of python scripting?
I had eaglecad installer (for the user to opt for it) included in previous version but i took it out. If it is needed I can put it back in a later version...
LTspice has a very good spice engine. It runs under wine (installed). Maybe it is a good idea...
Recently I tried a SCR simulation but i could not find a good model in LTspice. Qucs did well in the same task. I changed the parameters in the built-in model and gave accurate results. Besides that LTspice is very good.
I'll check about SDCC...