Getting Calibre to Spit out Layer Densities?

[DefconNowhere]

Dear Calibre expert:

I need to find out the density of a complex metal pattern on a chip. I run a DRC in Calibre but I cannot see any report anywhere mentioning the metal pattern density. Also to mention the metal density is within the min-max of the DRC deck so no DRC error is issued (otherwise I would see it of course).

Is there a way to get Calibre spit out layer densities even if they are within the DRC deck range?

In my experience, this practice was straightforward in PVS.

Thanks for any hint/help.

Kind regards,

DefconNowhere

 

[ahsrabrifat]

Not sure but these PDFs may help a bit.

https://s3.amazonaws.com/s3.mentor.com/training/toc/calibre-tvf_234638.pdf

https://static.sw.cdn.siemens.com/siemens-disw-assets/public/3sUlxERjZFcpkKb2V4kIXg/en-US/Siemens-SW-Transforming-IC-design-flows-Calibre-WP-81443-C4.pdf

 

[DefconNowhere]

Not sure but these PDFs may help a bit.

https://s3.amazonaws.com/s3.mentor.com/training/toc/calibre-tvf_234638.pdf

https://static.sw.cdn.siemens.com/siemens-disw-assets/public/3sUlxERjZFcpkKb2V4kIXg/en-US/Siemens-SW-Transforming-IC-design-flows-Calibre-WP-81443-C4.pdf

Thanks but no, they didn't help very much. I can run the nmDRC but I am looking for the density information. Either these are written out to a file I cannot find or not written at all and I need to set some switch to enable writing them out.

 

[DefconNowhere]

OK, no answer. Probably the Calibre nmDRC is not capable of doing so. God bless PVS and its simple and easy to use features.