Ethernet 802.3 Add-on Module Design

Status
Not open for further replies.

atmelAVR91

Member level 4
Joined
Aug 2, 2006
Messages
70
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,620
I want to design Ethernet 802.3 Addon Module with following features,

Hardware

1) 10/100 MBPS ethernet chip + configuration eeprom ( may be from Si Lab )
2) Microcontroller ( may be ARM7 from NXP/Phillips )
3) Uart Interface to Host Micro controller

Software

1) TCP/IP
2) WebServer
3) Custom Application

Please Guide me for developing above module.
 

budhy
any information for Lightweight WebServer ?
 

Hi

If you want we can make such board for you.
It's not clear what bit rate over Ethernet should this module support?

comp.vision (at) gmail.com
www.cv.tom.ru
 

That site has a a good explanation about lwIP, including user manual
 

I want good ethernet Controller with 10/100 PHY with 8/16 bit databus interface.

I also want to know whether I can do I/O Map for interfaceing with ethernet controller ( I am using NXP LPC21XX series microcontroller )

Thanks
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…