Amplifier Design with a large banwidth

Status
Not open for further replies.
That's correct - however, the circuit as shown in post#7 has a gain of +11. This should work in principle.

no it wont work. the circuit wil go to saturation practically! Vcc should be increased! then it will work.
 

no it wont work. the circuit wil go to saturation practically! Vcc should be increased! then it will work.

It's funny. The circuit drawing on my screen in post#12 shows +-12 volts. This should be sufficient for 0.3*10=3 volts output swing.
Do you refer to another circuit?
 

Hi LvW
In your previous post, you referred to the circuit in post 7. I presume that was just a typo, but explains the confusion.
 

Thank you all the circuit is working and I have integrated that to the system. I have a query which I have posted it as a new post.
 

Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…