Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Amplifier Design with a large banwidth

Status
Not open for further replies.
LvW said:
That's correct - however, the circuit as shown in post#7 has a gain of +11. This should work in principle.
Click to expand...

no it wont work. the circuit wil go to saturation practically! Vcc should be increased! then it will work.
 

msharmavikram said:
no it wont work. the circuit wil go to saturation practically! Vcc should be increased! then it will work.
Click to expand...

It's funny. The circuit drawing on my screen in post#12 shows +-12 volts. This should be sufficient for 0.3*10=3 volts output swing.
Do you refer to another circuit?
 

Hi LvW
In your previous post, you referred to the circuit in post 7. I presume that was just a typo, but explains the confusion.
 

Thank you all the circuit is working and I have integrated that to the system. I have a query which I have posted it as a new post.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top