Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
When I use ADS's RFPro to simulate and solve,
it shows that an error has occurred in the FEM state machine.
I would like to ask what the reason is. Is it because my computer does not have enough memory?
Try to monitor memory usage during the simulation. If your system is low on memory. You can Reduce the complexity of your model. Simulating a lower frequency or with fewer points.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
