Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ADS Rectifier Design problem

Q

qis

Newbie
Newbie level 1
Joined
Jun 12, 2024
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
9
Hi, I'm still new in using ADS. So, I tried to design a voltage double rectifier. But, when I tried to simulate it gives me a warning that 'no source was found'. May I know what the problem is?

11.JPG
12.JPG
 
Hi,

it's quite a while ago since I used ADS, but is it even possible to run both analyis at the same time? Have you tried to run the simulation when only TRANSIENT or S-PARAMETERS is enabled. Further, is P_1Tone actually connected, its connection might be coverd by the width (1.5 mm) of the MLOC.

BR
 
You cannot connect Port and Terminal in parallel. Port already has an internal impedance.
 

LaTeX Commands Quick-Menu:

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top