Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Looking for papers about CMOS Matching

Status
Not open for further replies.

unit900

Junior Member level 1
Junior Member level 1
Joined
May 8, 2006
Messages
16
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,281
Activity points
1,403
Hello,

Can you help me electronic version of two papers:

1. Easy-to-use matching model. IEEE Solid State Circuits Aug. 2002
2. J. Bastos "Matching characterizion of MOS transistors for analog design.

Thank you in future.
 

matching properties of mos transistors

There is another good paper for mismatch May it helpful for you.


Understanding MOSFET Mismatch
for Analog Design


Abstract�Despite the significance of matched devices in analog
circuit design, mismatch modeling for design application has been
lacking. This paper addresses misconceptions about MOSFET
mismatch for analog design. t mismatch does not follow a simplistic
1 ( area) law, especially for wide/short and narrow/long
devices, which are common geometries in analog circuits. Further,
t and gain factor are not appropriate parameters for modeling
mismatch. A physically based mismatch model can be used to
obtain dramatic improvements in prediction of mismatch. This
model is applied to MOSFET current mirrors to show some
nonobvious effects over bias, geometry, and multiple-unit devices.
Index Terms�Analog circuits, mismatch, semiconductor device
modeling, SPICE.

Added after 11 minutes:

you can search the first paper in this site.

Added after 11 minutes:

Abstract �This paper is concerned with the design of precisionMOS
anafog circuits. Section ff of the paper discusses the characterization and
modeling of mismatch in MOS transistors. A characterization methodology
is presented that accurately predicts the mismatch in drain current
over a wide operating range using a minimumset of measured data. The
physical causes of mismatch are discussed in detail for both p- and
n-channel devices. Statistieal methods are used to develop analytical
models that relate the mismatchto the devicedimensions.It is shownthat
these models are valid for smafl-geometrydevices also. Extensive experimental
data from a 3-pm CMOS process are used to verify these models.
Section 111of the paper demonstrates the applicationof the transistor
matching studies to the design of a high-performance digital-to-analog
converter (DAC).A circuit designmethodologyis presented that highfights
the close interaction between the circuit yield and the matching accuracy
of devices. It has been possibleto achievea circuit yield of greater than 97
percent as a result of the knowledgegenerated regarding the matching
behavior of transistors and due to the systematicdesign approach.
 

    unit900

    Points: 2
    Helpful Answer Positive Rating
mos matching

Thank you very much.

But if you have, can you upload this following papers:

1. Current mirror layout strategies for enhancing matching performance.
Analog Integrated Circuits and Signal Processing Jun. 2001

2. Layout dependent matching analysis of CMOS circuit. Analog Integrated Circuits and Signal Processing December 2000

Thank for future.
 

easy-to-use matching model

thanks very much
 

matchen cmos

I am finding this , thanks!
 

matching in multiple transistors pelgrom

unit900 said:
Hello,

Can you help me electronic version of two papers:

1. Easy-to-use matching model. IEEE Solid State Circuits Aug. 2002
2. J. Bastos "Matching characterizion of MOS transistors for analog design.

Thank you in future.

Following topic may be of your interest - - -



sankudey
 

understanding mosfet mismatch for analog design

thank you for the papers!
 

wiki matching in cmos

Thanks for the papers ...
 

CMOS Matching

for good reference refer AT OF ANALOG LAYOUT book its gives u a good idea of MATCHING
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top