Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to delay a 10Gbps signal in CMOS

Status
Not open for further replies.
B

beabroad

Member level 4
Member level 4
Joined
Nov 24, 2003
Messages
76
Helped
3
Reputation
6
Reaction score
2
Trophy points
1,288
Activity points
628
i want to design a CMOS subcircuit to delay 10Gbps signal, and find the inverter can not work for they introduce too much capacitance.

i am considering transmission line. any idea? thanks.
 

try single stage - cascaded - distributed amplifier (SSCDA).

this might provide the delay you need. it is basicely cascaded inverters but using inductive peaking technique to increase the bandwidth.

there are a lot of papers on this topic in IEEE.

Hope this will help!
 

    B

    beabroad

    Points: 2
    Helpful Answer Positive Rating
is distributed amplifier too large for the circuit? it needs inductors. or maybe i can use transmission line to replace the indutor
 

beabroad said:
is distributed amplifier too large for the circuit? it needs inductors. or maybe i can use transmission line to replace the indutor
Click to expand...


I really dont know, it depends on how much delay you want. and i dont think the transmission line on the chip will provide too much delay by itself.

if you put the transimission line off chip, it is another story.
otherwise, i think using inductor would be more area effcient than transmission line.

and for cascaded single stage DA, just one inductor for one stage. and if you want more delay, put more stages. and the delay is the result of using both inductor and capacitor.
 

    B

    beabroad

    Points: 2
    Helpful Answer Positive Rating
how about using delay cell of ring oscillators? can it provide enough bandwidth and delay?
 

Hello ,

how about using a buffer,by using this u can get some delay

Regards
Raj
 

    B

    beabroad

    Points: 2
    Helpful Answer Positive Rating
good point. another problem is which kind of buffer is better?
i used to use series of inverters, but 10G is too fast to use that.
 

RC circuit?
 

how about a microstrip delay line ?
 

Could the following help you....
IEEE,JSSC,NOV-2005,A monolithic Digitally controlled delay elemnt, M Maymandi...
it says in 0.18umCMOS, from 2ps above delay resolution...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top