Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[PIC] 6 Step Digital Automatic Voltage Stabilizer

Status
Not open for further replies.
sir milan rajik can you post your adc sence section c code .because i am writing a steblizer code but i stuck in adc methode thanks sir
 

milan.rajik sir can you post your adc sence code .actualy i am writing a code for steblizer but i am stuck in adc sence methode .
Thanks sir
 

You didn't mention about the LED ? When should the LED turn ON or OFF ?
 
What is the adc input voltage when AC input is 240V ?

@S0y

Post your Stabilizer circuit. I will have to see the adc circuit.
 
sir led is not importance so i remove led from my transformer.

- - - Updated - - -

sir it is top of thread

- - - Updated - - -

https://www.edaboard.com/attachments/107118d1404791171t-my-project.jpg
 

see my adc sence milan.rajik sir
 

Attachments

  • steblizer adc.pdf
    26 KB · Views: 299
Last edited:
What does 5V adc input represent ? 230V, 270V, 300V ?
 
245v=0.60v,200v=0.48,
 
Modify your ADC input circuit such that 300V is represented by 5V. I will then write a code for you. 0.6V for 245V is very less. You will get 0.44V for 180V.

Just drop the AC voltage to 6 or 7 volts and pass through half wave or bridge to get around 4.7 to 5V at adc input for AC 300V.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top