Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

|Z| probes and Agilent PNA

Status
Not open for further replies.
Leron

Leron

Member level 1
Member level 1
Joined
Apr 11, 2002
Messages
34
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
192
Hi All..
I don't know if this is the right forum but let's try...
I have a problem: I don't know where to put the electrical parameters if my Suss Microtech |Z| probes in the calibration program of an Agilent E8361A PNA. I would like to perform an on wafer LRM calibration.
Thanks for your help
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top