Working Problem in DevKit8000 (Beagleboard)

Status
Not open for further replies.
C

CfmC

Newbie level 2
Joined
Sep 13, 2010
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,295
That problem has been after when I tried to load wince system to the Nand flash. Firstly I chose 2. or 3. and it's about 'erase' , after that I upload files from SD card and xldrnand wasn't in sd. It couldn't copy too. After that board hasn't work again.
I can't communicate with board on COM port. Leds don't show connectivity. Only 3 leds are on and not blinking.(led33, led50 and led1). when I plug mini usb then pc warns me for OMAP3430 driver.
please can someone help me.
 
Last edited:

I solved problem. when i upgraded angstorm to wince, downloaded damaged and wrong file. that's why i think it couldn't start up with necessary files.Because i changed them.
I installed all angstorm files to SD card and powered on with it. I loaded system from it and it works fine.
 

I guess this should be posted to the support forum of the vendor
 

CFMC, you could give more details about the Angstrom used?
Where do you get? Which version? As such the U-boot setup ...
I'm trying to use the months newer version of the Angstrom Devkit8000 and I can not ...
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…