Working Problem in DevKit8000 (Beagleboard)

[CfmC]

That problem has been after when I tried to load wince system to the Nand flash. Firstly I chose 2. or 3. and it's about 'erase' , after that I upload files from SD card and xldrnand wasn't in sd. It couldn't copy too. After that board hasn't work again.
I can't communicate with board on COM port. Leds don't show connectivity. Only 3 leds are on and not blinking.(led33, led50 and led1). when I plug mini usb then pc warns me for OMAP3430 driver.
please can someone help me.

 

[CfmC]

I solved problem. when i upgraded angstorm to wince, downloaded damaged and wrong file. that's why i think it couldn't start up with necessary files.Because i changed them.
I installed all angstorm files to SD card and powered on with it. I loaded system from it and it works fine.

 

[Frank.J]

I guess this should be posted to the support forum of the vendor

 

[do interior]

CFMC, you could give more details about the Angstrom used?
Where do you get? Which version? As such the U-boot setup ...
I'm trying to use the months newer version of the Angstrom Devkit8000 and I can not ...