branek
Junior Member level 3
- Joined
- Jun 14, 2001
- Messages
- 30
- Helped
- 1
- Reputation
- 2
- Reaction score
- 0
- Trophy points
- 1,286
- Location
- SERBIA
- Activity points
- 215
Hello,
I ask a question about this strange behavior of PROTEUS some time ago, and now I have it again!
I can't debug interrupt routine! On picture below you can see that on the left side there is no ROM addresses, so I can't put a break on the line!
Anyone else have similar problem!?
I am using P*OTEUS 6.2SP5 and HITECH PI*C 8.01PL3!
// Moved from PCB Routing & Schematic Layout software & Simulation
I ask a question about this strange behavior of PROTEUS some time ago, and now I have it again!
I can't debug interrupt routine! On picture below you can see that on the left side there is no ROM addresses, so I can't put a break on the line!
Anyone else have similar problem!?
I am using P*OTEUS 6.2SP5 and HITECH PI*C 8.01PL3!
// Moved from PCB Routing & Schematic Layout software & Simulation