Wien Bridge oscillator analysis

W

wien

Newbie level 6
Joined
Jun 8, 2024
Messages
13
Helped
0
Reputation
0
Reaction score
1
Trophy points
3
Activity points
75
This is a circuit diagram that sets the resonant frequency to 110 kHz. I want to change the resistance, voltage, and capacitor values so that the resulting values have a voltage of 10 v, a current of 2 A, and a resonance frequency of 110 kHz. How can I change it? You can change any value, so please suggest a value. Thank you for reading it.
 

Sort by date Sort by votes
The circuit is fake. AD8099 is designed for +/- 5V supply, not +/- 100 V. There's also no sense in using a GHz OP for 100 kHz power oscillator.

Wien bridge doesn't achieve good sine quality without an amplitude control circuit. As for 2A output current capability, you can use separate output buffer or power OP.
 
Upvote 0 Downvote
In simulation...
The R & C values are already close enough to yield 105 kHz.

Place a 5 ohm load at the output. The op amp only needs supply rails +10V -10V. It should be a power op amp.

If your spec current is RMS, then make supply rails sufficient amplitude to yield your spec value.
 
Upvote 0 Downvote
In addition to all former comments:
When you need a specific signal amplitude of a "good" sinusoidal output, you must use a well-designed amplitude-limiting mechanism.
Otherwise the sgnal will be hard-limited (clipped) at the opamps maximum possible output voltage.
 
Upvote 0 Downvote
Which opamp should I use, and how should I amplify it when the current is too small?
 
Last edited by a moderator:

Upvote 0 Downvote
You must log in or register to reply here.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…