Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Why use SiO2 and layer on Si substrate to fabricate CNTFET's

Status
Not open for further replies.

roshan12

Junior Member level 2
Junior Member level 2
Joined
Dec 20, 2013
Messages
21
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
203
In the fabrication of Carbon Nanotube FETs, the nanotubes are placed on the Si substrate over a layer of SiO2. Is this done to increase the band gap of the material or just to improve the adherence to the substrate??
 

Attachments

  • Capture.JPG
    Capture.JPG
    28.7 KB · Views: 115

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top