Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Why net delay calculation in report_timing and report_delay_calculation are different? - ASIC Synthesis(Synopsys DesignCompiler)

Status
Not open for further replies.
S

sivaji.satya

Newbie
Newbie level 2
Joined
Sep 28, 2020
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
18
After specifying Wire Load Model and constraints to a design (in1 is connected to inverter and inverter output is connected to Dflop input), wire delays for the below two commands are different. Why?

>report_timing -from in1 -to reg1_reg/D -nets -input_pins
>report_delay_calculation -from in1 -to inv1/A
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top