Why is there a difference between the IP3out of ADS simulation OIP3 and the result of self-drawing

Status
Not open for further replies.

ianian12377

Newbie
Newbie level 4
Joined
Mar 22, 2023
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
43
Hi this is the amplifier I am currently designing and want to simulate the OIP3 at POUT 23 dBm,
From this figure, it can be known that when Pin = -13.8 dBm, Gain = 36.8 dB and Pout = 23dBm.
1679474329123.png
Use 2TONE on ADS and set Pin = -13.8 dBm.

1679474631393.png
Using the tool IP3out, the OIP3_lower and OIP3_upper can be obtained as 37.87 dBm and 39.79 dBm respectively
1679474718191.png
But I use the analog method of this picture to draw the picture:
1679474831608.png
It can be known that: IM3_lower = -15.77, IM3_upper = -19.62

Draw the intersection points with slopes of 1 and 3, and find that the intersection points will be at 42.39, 44.31

Excuse me, why is there a difference between the junction point of self-drawing and the result of using ADS IP3out? Thank you very much
 

Start Pin_avs from much lower values and plot the straight lines from this point. You plotted straight lines almost where the nonlinearity starts at.
 

Status
Not open for further replies.