Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Where should the code sit in MPC565? (using CodeWarrior)

Status
Not open for further replies.
A

arvind053

Newbie level 4
Newbie level 4
Joined
Jun 23, 2004
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
69
mpc565 memory map

I am trying to port uC/OS on a MPC565 uProcessor (Phytec). I seem to be running into some conflict wrt Code and Stack addresses. Specifically, my OS throws exceptions because of (poss.) address overlap.

Does anyone know where in the processor should the code, data and stack sit ? I went thru the Memory model provided for the MPC565 and the eval. board, but no luck so far. :cry:

Any help wud be greatly appreciated !!

P.S.: I'm using the Metrowerks CodeWarrior compiler. (I know gcc rulez!)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top