Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Where are resistors on 8 x resistor array?

Status
Not open for further replies.
T

treez

Guest
Newbie level 1
For the “CAY-16 J8” resistor (8 resistors on a chip), do you know if the resistors are where the “concave” bits are, or where the “straight” bits are?

https://www.bourns.com/docs/Product-Datasheets/CATCAY.pdf

...i was looking for the "pitch" measurement marker to help to tell us, but cant find that.

8 x resistor array
https://www.bourns.com/docs/Product-Datasheets/CATCAY.pdf


The datasheet says "CAY16" is "convex terminations"...but none of them have convex terminations...they are all either straight or concave
 

Looking at page 3, the land patterns indicate the connections are on the concave section for the CATxx series and the flat part for the CAYxx series.
 

The datasheet says "CAY16" is "convex terminations"...but none of them have convex terminations...they are all either straight or concave
You could post this in a language criticism forum. Hardware engineers know that the straight resistor array terminals are commonly called konvex. Apart from this point, I believe you have posted before reading the datasheet twice. There's everything in it, also the pin pitch measure "C". Other manufacturers publish suggested footprint patterns in addition, e.g. Vishay. Might be a separate document at Bourns.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top