Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What to do with floating pins in Orcad 9.2 software?

Status
Not open for further replies.
B

Bavananth

Newbie level 5
Newbie level 5
Joined
Apr 5, 2008
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,359
Hi I trying to filter out some 2ms pulses(they are noise to me). So i'm planning to use TI's UAF42 as my 300Hz LPF. So i just wanted to simulate it before I make the cct. But in the cct diagram given by TI there are some floating points. But it is not allowed to leave pins floating in PSpice. What to do? I'm Using Orcad 9.2. ???? :cry
 

Floating Pins

I found out. Just Connect a wire to the pin and let the wire end to float. Some rediculas solution,nah? But it wrks....haha
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top