Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

What is the USB cable lump for?

Status
Not open for further replies.

Lord Loh.

Full Member level 4
Full Member level 4
Joined
Jun 19, 2004
Messages
196
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,296
Location
Texas
Activity points
1,951
I have noticed that some USB cables have got a lump near the connector while some do not.

What is the lump shaped device for? And what is inside it ?

Also I noticed that the cables with good devices had the lump while the ones whith low end devices did not have them.

My cannon camera had them while my PDA and the web cam did not.

**broken link removed**
**broken link removed**

B00006GF1X.01.LZZZZZZZ.jpg

The URL

Also while searching for the above pic I found one site write...NOT FOR MAC... I thought the USB specifications are universal.
 

what is lump on usb cable

Hello,

Usually this "lump" is a ferrite filter to filter any external or self induced interference, this is sometimes necessary for longer cables to achieve the maximum possible data transfer speed.

These filters are available in a lot of other interface cables: (telephone and netork (RJ-11 and RJ-45), monitor cables, etc.

For the "Not for MAC" I think the cable and physical interface is universal but the device using the USB may have firmware that is not compatible with MAC Operating system.

regards,

GAM
 

what is that lump on a usb cable?

some for hub some not
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top