Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

What is Auto MDIx port on Ethernet Switch

Status
Not open for further replies.

techie

Advanced Member level 3
Advanced Member level 3
Joined
Feb 5, 2002
Messages
839
Helped
58
Reputation
116
Reaction score
9
Trophy points
1,298
Location
Pakistan
Activity points
7,805
auto-mdix port

What is Auto MDIx and how it is done.
 

mdix port

Q: What is Auto-Sensing MDI/MDIX?
A: Auto-Sensing MDI/MDIX means that every port on the switch will automatically detect the Ethernet cable type being used (straight-through or crossover) and adjust to make a link over that cable. This means that the days of having to figure out which cable to use are gone. This is a massive improvement over previous hubs and switches where this functionality was only available on one hub/switch port through the manual operation of a mechanical switch (MDI/MDIX switch or Uplink switch).
 
mdix ethernet

Does that mean that RX and TX pairs can now be changed and the hardware in the switch will configure itself automatically as which pair is RX and which pair is TX.
How about the polarity of the wires. For example, inside the RX pair, if we reverset the connections (change orange with orange-white), does it still work.
 

ethernet mdix

techie said:
Does that mean that RX and TX pairs can now be changed and the hardware in the switch will configure itself automatically as which pair is RX and which pair is TX.
How about the polarity of the wires. For example, inside the RX pair, if we reverset the connections (change orange with orange-white), does it still work.
Yes, RX and TX pairs detected automatically
About polarity, it depends of realization (and it may working only on RX pair !) ..... ???
Better use right polarity cables, but you do not nead diferent cambles ( normal and crossover (X-cable) ).
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top