what cause modulation fail?

Status
Not open for further replies.
X

xinxin

Full Member level 3
Joined
Oct 8, 2003
Messages
184
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,298
Visit site
Activity points
1,238
What cause modulation fail when setting Low PCL of DCS or PCS band , except VCO , PLL part?
 

Modulation mask failure can be much words about the reason.
Except VCO and PLL, PA control loop stability at low PCL is one important thing worthy to be studied.

Some PAs need large capacitor to ensure loop stability for all PCLs, especially Mid& low PCLs. Some PA using power feedback would have problem of dynamic range of power detector on use. Make sure you PA control loop works without fret
of low margin.

Hope it works!
 

I use RF3146, but on an other project which use the RF3146, it is OK on modulation.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…