Waveguide Cutoff in HFSS

Status
Not open for further replies.
I'm not sure what do you mean ...

but If you are referring to how to demonstrate that a certain propagation mode has a certain cut-off frequency you have just to excite this mode and simulate it on the frequency range of interest.
 

simple, draw a piece of waveguide, do a full-band simulation, then you will see a "high-pass" response, which represents "cut-off"
 

What if you want an actual number, say for an optimization analysis?
 

You can you the prorogation constant, which is the im(gamma(portNumber:mode)). If you could be more specific as to what you are trying to optimize about the waveguide it would be helpful.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…