via between signal layer and plan layer in Altium

Status
Not open for further replies.
A

alibarghi

Member level 2
Joined
Jun 30, 2013
Messages
42
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Visit site
Activity points
1,559
How to switch and place via between signal layer and plan layer in Altium?
I switch between signal layers with "*" ; How do I switch between all layers(plane and signal)?
 

Are you trying to use buried or blind vias?
You dont have to switch between layers to place a via. In via properties , you can edit the via stackup or you can also edit the start and stop layers to make it burried/blind
 

GUMY said:
You have to enable desired layers first.
Click to expand...

Yes it is enabled


techgreed said:
Are you trying to use buried or blind vias?
You dont have to switch between layers to place a via. In via properties , you can edit the via stackup or you can also edit the start and stop layers to make it burried/blind
Click to expand...

Yes it is true, But this is a general way to create via between any layers, I am looking for a quick way to do it.
 

If you use all the vias in same fashion, you can change via defaults in DXp prefrerences.
Or use PCB Inspector panel to modify multiple vias.
 

thanks your replies.
I'm currently using this method but I tend to create a shortcut or Rule for it.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…