studystudystudy
Member level 1
i try to build a energy harvesting circuit from some material capable to generated electric when applied mechanical force such as piezo.
despite all value in the circuit.
can my circuit work with this schematic design?
1. V1 is the input source **(ignored the value of V1)
2. the two zener diode D1 and D2 used to limiting the voltage. (back to back zener diode concept)
3. general diode D3,D4,D5,D6 act as rectifier.
4. c1 is used to stored the amount of energy
5. D7 and D8 is used to voltage regulator
6. c3 is used to stored the energy
please refer and see the attachment below
thank you very much, your helps will deeply appreciated
despite all value in the circuit.
can my circuit work with this schematic design?
1. V1 is the input source **(ignored the value of V1)
2. the two zener diode D1 and D2 used to limiting the voltage. (back to back zener diode concept)
3. general diode D3,D4,D5,D6 act as rectifier.
4. c1 is used to stored the amount of energy
5. D7 and D8 is used to voltage regulator
6. c3 is used to stored the energy
please refer and see the attachment below
thank you very much, your helps will deeply appreciated