Using isolator to avoid damage to Amplifier.

Status
Not open for further replies.

adnan012

Advanced Member level 1
Joined
Oct 6, 2006
Messages
468
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Visit site
Activity points
4,923
hi,

Can i use an isolator to avoid reflected power coming back into the power amplifier. There is a chance , when antenna cable is not connected to the amplifier.
 

yes, that is the main reason they are used. You would need one rated for the power level, since all of the output power will be absorbed by the internal 50 ohm resistor.

Because they are big and expensive, a lot of transmitters just use a dual directional coupler, and shut down the power amp if too big of a load reflection is seen.
 
I want to get this isolator. Will it work for 50 watts reflected power?
 

Attachments

  • DI070SA_825-960MHz_Drop-In-Isolator.pdf
    98.9 KB · Views: 122

Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…