Use double balanced mixer as phase detector ?

Status
Not open for further replies.

khungbopro

Member level 1
Joined
Jan 8, 2013
Messages
33
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Visit site
Activity points
1,484
Hi all,
Have you ever use Double Balanced Mixer as Phase Detector (full 360 degree) ?
Theoretically, LO and RF signal have identical frequency, and the output at the IF is DC signal.
But I'm not sure it can be distinguished positive and negative phase differential between 2 signal at LO and RF port based on IF output signal :roll:

I've referenced in 2 documents:
1. wj using mixer as phase detector
2. ADE_Mixer_As_Phase_Detector.htm

Can you help me solve this problem :?:
Thanks in advance!
 

If you regard one waveform as sampling the other, depending on the relative phases, you can get Vmax X .8 values at two different phase differences. its is best if the signals are in quadrature, this gives you a linear - 90 degs to +90 degs output. You will also need a non-ambiguous detector, to over come the two phases for one DC output.
Frank
 
I want to use phase detector for wide band (~30 MHz bandwidth in HF).
Could you guide me to design a "non-ambiguous detector" to distinguished positive and negative phase differential !?
Thanks!
 

**broken link removed**

there are analog ramp based phase detecors.

There are digital flip-flop based phase detectors 720 degrees operation
 
Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…