urgent help designing an amplifier with AWR

Status
Not open for further replies.

babak.amoun

Newbie level 3
Joined
Jan 28, 2013
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,305
Hello everybody
will be thankfull if anybody can help me soon
i need to design an amplifier by AWR microwave office by a transistor with following parameters
vce=10 volt, ic=2mA, f=400MHz
yie=7+j11.5
yre=0-j0.9
yfe=37-j37
yoe=0.2+j5
this amplifier must have the stability factor k=2
and also need a method to measure noise equivalent resistor in this transistor

is all these can be done with AWR microwave office?
and if so please someone tell me what should i do
Regards Babak
 

First go find a transistor that meets your requirement. Read the data sheet, look at the
design suggestions and go from there.

You may find a device that will meet your needs but just putting a 50 Ohm input and
output trace to the amp.
 

search nxp freescale etc to find a transistor download it model .. i suggest to use ADS for designing.
 

For simplicity, you'd better to convert y-parameters onto s-parameters to able to do s-parameter simulation.For noise,you can calculate Optimum Noise Admittance by using y-parameters.For more info, see textbooks...
 

Status
Not open for further replies.

Similar threads

Cookies are required to use this site. You must accept them to continue using the site. Learn more…