Ultiboard11: placing SMD components on both layers

Status
Not open for further replies.
B

bwana1

Junior Member level 3
Joined
Dec 1, 2009
Messages
30
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
italy
Activity points
1,560
Which way, if there is one, one can place SMD components on both PCB sides using Multisim11 Ultiboard?
In the case this were not possible, can you please address a suitable PCB capture/editor program?
TIA
 

i recommend proteus , it is an easy program, or for complex design use altium designer
 
Reactions: bwana1

    B

    bwana1

    Points: 2
    Helpful Answer Positive Rating
I don't use Ultiboard but I am sure you can put SMD components on both sides! You don't need some other software.

Keith
 

You're right, Keith.
I went not as deep as I should into help. Following your suggestion I found there's
a "mirror command" to place the SMD on the opposite layer.
Thanks.
 

there will be no any problem while placing smd components on both the side of the pcb .it can be done side as well as both the sides.it might be helpfull.
thanks
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…