JustMet
Newbie
Hello Community Members,
I have created a TMR Microblaze system and connected the output UART to the Tx and Rx pin using the MIO option on Zynq+ When I generate a bit file and add an associated elf file to it, I cannot see the option to program the Zynq processor and therefore I cannot see the output of the Microblaze using the putty terminal using a serial connection.
Best regards
JustMet
I have created a TMR Microblaze system and connected the output UART to the Tx and Rx pin using the MIO option on Zynq+ When I generate a bit file and add an associated elf file to it, I cannot see the option to program the Zynq processor and therefore I cannot see the output of the Microblaze using the putty terminal using a serial connection.
Best regards
JustMet