transformer in spice simulation problem

Status
Not open for further replies.
A

andy2000a

Advanced Member level 2
Joined
Jul 18, 2001
Messages
597
Helped
14
Reputation
28
Reaction score
8
Trophy points
1,298
Activity points
5,298
hspice transformer

Hi
I make a transformer simulation model

XFORMER21 N1 N2 N3 N4
VM1 N9 N7 DC 0
RS1 N3 N9 1U
E1 N7 N4 N1 N2 20
F1 N1 N2 VM1 20
RP N2 N1 1MEG

but I find I use mos switch in N2 (N1 is input Vcc) on/off
I already set N3/N4 ration= 10 * v(N1, N2)
but N3 N4 no output signal ,
because N1 N2 signal is very small
because pwr_mos Rds is small..

how to really simulation power_mos & transformer in hspice ?
 

Hi,

Dont really understand your model, but F1 (F1 N1 N2 VM1 20) is controlled by VM1 which is set to DC 0 (VM1 N9 N7 DC 0) with no AC value ?
 

I find some textbook only DC , no AC value

and I find another model in

**broken link removed**

see spice transformer.html

, I don't know why use K , some circuit simulation use L+K set K-> 0.99999
but another model use behavior model which is better ?

and another problem is use L in hspice usually cause "no convergency simulation .."

I hope some designer can give me a PWM + transformer spice netlist
basic PWM like "forward "
 

l1 1 0 2000
l2 3 4 20
riso 4 0 10meg
k l1 l2 0.999999999
rs 2 1 0.1
rl 3 0 100
vin 2 0 sin(0 170 60 0 0)

.OPTIONS post=1
.op
.tran 0.01m 44m

.probe tran v(vin) v(1) v(2) v(3) i(l1) i(l2)
from L1 L2 ration is 10:1 , input 170v AC signal
but I use hspice simulation v(3) signal is very very small ..
why ??
 

It looks like your transformer is not connected properly. You have the output 3 and 4 but you connect one terminal via a large resistor to ground and measure the other terminal to ground through a small value resistor. Try measuring the (3.4) terminal pair.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…