to amplify signal- must not to non linear!

Status
Not open for further replies.
Dc: 0-100 V

- - - Updated - - -

this is a dc voltage in the range of 0-100 V
 

Hi,

it is a 2nd order sallen key low pass filter.

If your connections are right, then it should have an input range of about +/- 200V.

Is your R7 able to dissipate 30W of power?

Connect GND_Ref (C1, R3) for the OPAMP directely with extra wire to R8.
Connect R2 directely with extra wire to R8.

Klaus
 

The R7 is load which its current sensed with the R8.
I have problem in practice;No in simulations!

Rasool,
 

please suppose,
in=33 V ==> out=1.4 V

in=66 V ==> out=2.6 V ! which should be 2.8 V
 

Hi,

What is R7? Is it a true resistor?
Or is it a copper wire, a heating device, a light bulb, or something else? If so, then this is the problem. It is non linear.


Klaus
 

Yes,
It is good point.
I should to test it ( in next days ).

regards,
Rasool
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…