Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

the concept of mode-locked laser

Status
Not open for further replies.

hellotxn

Member level 4
Member level 4
Joined
Dec 11, 2003
Messages
79
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Visit site
Activity points
575
Could someone give me a clear explaination about the concept of mode-locked laser?Or recommend some reading material to me?

Thanks!
 

I assume you are looking for a basic level discussion. So I’ll try to make it simple:
Imagine a simplified laser structure; a long active medium and two mirrors at the end
If you can generate a very narrow pulse of light, that will bounce back and forth between the mirrors (at each reflection loses some power outside, that power is recovered during the travel in the active medium). The output will be periodic pulses, separated by the internal roundtrip time.
Normally if the active medium is powered continuously then the light in the laser will also be continuous, not pulse.
So a mode locked laser is one that uses some means of generating (and maintaining) a pulse traveling inside. This is achieved usually by the presence of some sort of switch (electro-optic, electro-absorptive, acousto-optic etc) inside the laser cavity.
Mathematically speaking what happens is that a laser oscillates on multiples of the fundamental resonant frequency of the cavity (actually it is more complicated but for now it is something like that). Typically the central frequency of interest corresponds to the mode order 5000 or so. But other modes will also be present like order 5001, 5002, 4999, 4998 etc. If you combine these modes with the right phase (and amplitude) you can obtain the desired pulse. That is were the mode locking or coupling name comes from, the modes are locked in phase. In practice, as I said, a switch is used, blocking everything except the desired pulse interval – this way the pulse is obtained from an otherwise uniform random combination of modes.
 

    hellotxn

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top