Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Increase input impedance and set gain. Input impedance at T1 base node is low due to voltage controlled current ("shunt-shunt") feedback, not suited for dynamic microphone.
I think the amplifier topology isn't first choice for microphone amplifier. Suggested load impedance for standard 200 ohm moving coil microphones is > 1k, even higher for 600 ohm type.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
