jaikumal
Newbie level 1
- Joined
- Dec 10, 2012
- Messages
- 1
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Activity points
- 1,290
Hi dear all,
I have simulated one block using XA (fast spice simulator). It took approximately 2 days to complete the job. But unfortunately in the measurement statement, i made some small mistake that is not giving me the frequency of the output in .meas (.mt0) file. But if i load the corresponding fsdb in SX and observe the waveform it is coming proper.
Now if I'm gonna simulate the circuit one more time, it takes 2 days and i have to wait till it completes. So, can anybody guide me, without simulating circuit , is it possible to measure the parameters by just using available fsdb file ???
if i had it for one corner, i would have manually measured it.. but I'm running for 56 corners. Pls pls pls.. help me out of it..
Thanks,
Jai
I have simulated one block using XA (fast spice simulator). It took approximately 2 days to complete the job. But unfortunately in the measurement statement, i made some small mistake that is not giving me the frequency of the output in .meas (.mt0) file. But if i load the corresponding fsdb in SX and observe the waveform it is coming proper.
Now if I'm gonna simulate the circuit one more time, it takes 2 days and i have to wait till it completes. So, can anybody guide me, without simulating circuit , is it possible to measure the parameters by just using available fsdb file ???
if i had it for one corner, i would have manually measured it.. but I'm running for 56 corners. Pls pls pls.. help me out of it..
Thanks,
Jai