STM8S003F3 ADC single scan mode

Single scan mode.
This mode is used to convert a sequence of analog channels from AIN0 to AINn where ‘n’ is
the channel number defined by the CH[3:0] bits in the ADC_CSR register. During the scan
conversion sequence the CH[3:0] bits are updated by hardware and contain the channel
number currently being converted.

Click to expand...

vinodstanur said:

Hi,
recently I started playing with stm8s microcontroller, I am using stm8s003f3 microcontroller.
I am planning to use SCAN MODE in adc. From the datasheet it seems like scan mode can happen only from ADC0 to ADCn where n is the channel number.


But in the stm8s003f3 the ADC channel numbering starts from ADC2. (ADC2 to ADC6 (5 channels))
So I am a bit confused how to configure the SCAN mode channel limit settings.

Click to expand...

hardik.patel said:

Hi...vinodstanur,

I am planning to start with STM8S003F3, so can you please tell me from where i can get that discovery kit...

and about how much its costly??......which compiler for it we can use, specially with 'C' language..??



Regards,

Click to expand...