kunal123
Advanced Member level 4
- Joined
- Jan 24, 2011
- Messages
- 105
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,296
- Location
- mumbai
- Activity points
- 1,961
hello,
i want to interface two stepper motor to microcontroller, facing some problem, when i connect two motor to microcontroller through l298n stepper motor driver, but only one motor work properly, i connect both motor in similar maner(wiring, external supply), i need help to solve this problem, also l298n motor driver ic's maximum current capability is 3A, i give supply to driver circuit 12V 2A but after 15 min motor driver ic is going to heat, what can i do?
i want to interface two stepper motor to microcontroller, facing some problem, when i connect two motor to microcontroller through l298n stepper motor driver, but only one motor work properly, i connect both motor in similar maner(wiring, external supply), i need help to solve this problem, also l298n motor driver ic's maximum current capability is 3A, i give supply to driver circuit 12V 2A but after 15 min motor driver ic is going to heat, what can i do?